Did a bit of do or die and connected 4.5v to vcc pin 8 of the eeprom I can't read. Seems to have done the trick and I can now read the contents. Unfortunately I can't decode them. I'm going to email s ...
Not having much luck here. Was using the simple interface, but decided to build the driven interface. Still cant read the eeprom and address is set to 0xA0. Just get the eeprom not available error.
...
Had to remove the board again and solder some new wires onto eeprom. Anyway this is what I get:
Pin 1 - 0v
Pin 2 - 0v
Pin 3 - 0v
Pin 5 - 3.3v
Pin 6 - 0v
The other eeprom is having a different address and Pony is set to 0xA0. Check how the pins 1-2-3 logics are, if they are all 1 (3.3V) then the addres is 0xAE and must be edited in ponyprog2000.ini
I've been battling with a toshiba M10 for a few days now and don't seem able to bypass the startup password. There are two 24c02 eeproms on the main board, one on each side. Using ponyprog I can read ...