|
Service Forum support board, PC repair, unlocking solutions
|
View previous topic :: View next topic |
Author |
Message |
Novaax Nou Venit
Joined: 21 Jan 2020 Posts: 2
|
Posted: Tue Jan 21, 2020 8:56 pm Post subject: T42 Error |
|
|
Hi all ! I read all guide about read eeprom,but i have a little problem with error messages after i try to read eeprom with CMD commands
1 one time i get :
Initializing timer...53688 OK!
ERROR: Circuit not found or bus error!
----------------------------------------------------------------
Hit <Enter> to exit...
2. i get this
Initializing timer...52023 OK!
ERROR: Eeprom not available!
i connet wire it the same order like 1 and i get this .... any help ? ty for ur time ! |
|
Back to top |
|
|
victor S.F. Boss
Joined: 07 Mar 2004 Posts: 2581 Location: Staff
|
Posted: Tue Jan 21, 2020 10:37 pm Post subject: |
|
|
I need more than this to be able to figure out what you did there. _________________ Victor Voinea
ALLservice HQ, Romania. |
|
Back to top |
|
|
Novaax Nou Venit
Joined: 21 Jan 2020 Posts: 2
|
Posted: Tue Jan 21, 2020 10:48 pm Post subject: |
|
|
oh, ok i am with win 10 pro i have usb to rs232 (model:u232-p9) after this i connet cable to female 9pin and after this i solder the componets 2x2200 ohm and 2x zener diods after this i solver 3 cable to the eepro chip ground sda and scl then i open the cmd comander on my pc and type commad to save the dump next i turn on laptop pres f1 to enter in bios mode wait and when show lock icon i start to connet solver first ground then sda then scl after this i press enter and this messages show ups and i save dump but with 0kb |
|
Back to top |
|
|
victor S.F. Boss
Joined: 07 Mar 2004 Posts: 2581 Location: Staff
|
Posted: Tue Jan 21, 2020 10:52 pm Post subject: |
|
|
These USB adapters won't work unless they are $50 ++
Even then, I would not recommend them. So here is one issue. _________________ Victor Voinea
ALLservice HQ, Romania. |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|