Service Forum

bob · Posted: Sun May 14, 2006 1:03 am Post subject:

Nice!

All 600x users should be greatful for this tip Wink

Anybody could see that you love what you do. Keep up the good work!

Cheers

basscleff · Interesat Joined: 27 Mar 2006 Posts: 19 Location: Canada

Hi, thanks again for the great tutorial. has anyone any information on alternative solder points for a T40?

thx

willy_oli · Nou Venit Joined: 04 Jun 2007 Posts: 2

I'm have TP 600E, when solde the wires in the chip, my tp not work, start but in black screen.

the led on/off correctly.

victor · S.F. Boss Joined: 07 Mar 2004 Posts: 2581 Location: Staff

1. If this is happening even without connectig the SDA and SCL wires to the interface - > you made a short circuit!

2. If this is happening WHEN the wires are connected to the interface - >

a) you've soldered the wires to the other end of eeprom. There's nothing particular with the SDA and SCL but the GND is tied to Vcc pin...

b) the interface is totally wrong and screwed up the signals and everything else..
_________________
Victor Voinea
ALLservice HQ, Romania.

willy_oli · Nou Venit Joined: 04 Jun 2007 Posts: 2

Hi Victor Thank for you dedication.
In this moment, the interface is not conected to the 24RF08, and I´m mount the machine again for test. But no .. the machine follow with the black screen, and light led normaly.
I´m not see shortcut.
The Eeprom is 24RF08BT, do you know if pin to conect are GND 6, SDA 8 SCL 10??

Thank

bob · Posted: Fri Jun 08, 2007 11:24 pm Post subject:

Hi,

The pins are correct, whatch out for the #1 pin, it is marked on eeprom