Service Forum

fryser · Nou Venit Joined: 21 Mar 2007 Posts: 8

^Thx but it doesn't work I tried everything Smile

I have a sick idea... I tried to read the data, get the pass then unblock it.

Can I get the "yourbin.bin" from a guy then, overwrite my eeprom (without a pass) Question

bob · Posted: Sun May 13, 2007 11:34 am Post subject:

If you couldn't read the chip why do you think you could flash it? Your circuit doesn't work ...

Thats is not an option, you have to solve the problem with the interface/tech PC and read the chip. Besides the W24RF08 is not free...

Build the driven programmer, take it slow and easy and you will succeed sooner or later.

kandi · Nou Venit Joined: 08 Jun 2007 Posts: 4

After weeks of trying to obtain the password I need help.
After building 5 different circuits and getting the same error I brought a 24RF08 reader from the states.

I've attached the reader and soldered the three wires as shown in the guide.

Even without the wires connected to the laptop I don't get the Circuit unavailable message but the EEprom not available message.

The only time I get a positive reaction is when I use the command

"r24rf08 /i dump.bin"

which then gives me
"reading eeprom
>>>>>>>>>
Done.
1024 bytes saved in /i"

What does "Saved in /i" mean?

Can anyone enlighten me as I am about to launch this T41 from 4 storeys up.

bob · Posted: Fri Jun 08, 2007 11:17 pm Post subject:

for driven i2c programmer:

kandi · Nou Venit Joined: 08 Jun 2007 Posts: 4