Service Forum

anyone_8542 · Nou Venit Joined: 23 Apr 2009 Posts: 7

Hi everyone,

Can anyone give me some advice as to what chip is used in the D410 and where it is located on the motherboard??

Also what program and interface are needed to read the password.

Many thanks in advance.

bob · Posted: Thu Apr 23, 2009 2:34 pm Post subject:

D410 has 24C04 IIC eeprom.
You can use the driven interface or SIPROG and Ponyprog - or whatever else since this eeprom is a common one.
If you use PonyProg and the driven interface, invert the signals in interface settings.

Driven i2c: www.allservice.ro/forum/dl/driven-i2cprog.pdf
SIPROG: www.allservice.ro/forum/dl/simple-i2cprog.pdf

anyone_8542 · Nou Venit Joined: 23 Apr 2009 Posts: 7

Thanks for that, were on the motherboard is that chip??

Thanks

Traud · Membru Activ Joined: 30 Oct 2007 Posts: 40

under pcmia slot remove the black plastic

anyone_8542 · Nou Venit Joined: 23 Apr 2009 Posts: 7

Hi,

I have built the driven interface which is working fine with itester but when i try to use PonyProg i keep getting a message saying that the "communication port is not available(-16)"

Not sure what i'm doing wrong, can anyone help????

Is there another program i can use????

Thanks