 |
Service Forum
support board, PC repair, unlocking solutions
|
| View previous topic :: View next topic |
| Author |
Message |
fabiofly
Nou Venit
Joined: 29 Oct 2010
Posts: 1
|
 Posted: Fri Oct 29, 2010 5:16 am Post subject: R24RF08 software. |
 |
|
First thanks for the vary good job you are doing in this forum-
I was using my tp x41 when i found out i had to decode the svp to use it again.
Now i've done all the wiring and built the SI-PROG device to dump the eeprom file, i followed exactly the instraction in the tutorial but i don't know how to use the software R24RF08.
When i open that file i get the prompt with the usage instractions about the filename and switches and the final wards "hit enter to exit".
So when i put the filename in the last row i don't know how to start to dump the file.
Since i'm not an expert in programming pc i may miss something.
Could anybody halp me in the use of this R24RF08 software?
Many thanks
Fabio  |
|
| Back to top |
|
 |
victor
S.F. Boss
Joined: 07 Mar 2004
Posts: 2581
Location: Staff
|
| Posted: Fri Oct 29, 2010 10:50 am Post subject: |
|
|
Go this way:
Start Menu>Run > type in: | Code: | | c:\allservice\24rf08\r24rf08 dump.bin |
Then click <OK>
_________________
Victor Voinea
ALLservice HQ, Romania. |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
