Service Forum

Scrafe · Nou Venit Joined: 05 Apr 2006 Posts: 1

Hello.
I recently built the simple circuit interface for the 24RF08CT chip in my T22.
I already have some circuit building experience, and quadruple-checked all connections. I set up the equipment as per instruction, and followed them to the letter.

I launched the software via CMD interface, but recieved the error "eeprom not found."

I have already built the interface both on a pcb and as an integrated unit on the com port Dsub. The zeners have the proper polarity (blank end to ground.)

Any assistance would be greatly appreciated.
_________________
IBM Stinkpad: A world of headaches at your fingertips.

bob · Posted: Wed Apr 05, 2006 10:03 am Post subject:

If you are pretty sure all is perfect: circuit, COM1 connections, eeprom connections, then try using another PC. SIPROG is powered by the COM port itself.