Service Forum

[ko2003]

hey everyone i got my driven programmer in today...ok i put in the batteries hooked up the ground left the TPM1 and TPm2 wires in the air didnt even peel any of the coating from them...opend up iITester it keep going from sda 11- 00 etc i also checked the box it still done the same thing so i thought i was good to go ok...so i pelled the ground wire GND....soldered on an allgalitor clip.....then i soldered sharp tiny sewing needles to the wires TMP1 and Tmp2 ok.... now i was ready to go..


1.start run cmd
2.dir C:\allservice
3.dir C:\allservice\24rf08
4.C:\allservice\24rf08\r24f08.exe dumpT41.bin

5. started up the thinkpad press F1 to enter the bios so i did waited for all light to stop and the lock to show up..

6. then i got the sewing neddles held them on the legs of the atmel TPM1 on SCL and TMP2 on SDA..i was holding them tightly so i know they were making contact...i put blacktape on the needles to cover were i had soldered them and also so i could hold them...

7. then i hit enter eeprom not found or bus error

could someone tell me what im doing wrong i have brand new batteries in the programmer i even soldered the neddles to the legs so i know they are on there good.. are they anything else i can do? have i missed something?

[victor]

Hi,

You must add "/x /d /i" at the command.
r24rf08 dump.bin /x /d /i
_________________
Victor Voinea
ALLservice HQ, Romania.