ALLservice Service Forum
support board, PC repair, unlocking solutions
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

lifted pad pin2 p24s08

 
Post new topic   Reply to topic    Service Forum Forum Index -> Hardware, BIOS repairs
View previous topic :: View next topic  
Author Message
JSMOKE
Nou Venit


Joined: 13 Jun 2012
Posts: 1
PostPosted: Wed Jun 13, 2012 7:37 pm    Post subject: lifted pad pin2 p24s08 Reply with quote
I lifted the pad @pin2(L2) of where p24s08 is located on my ibm r500 mainboard. My question is does this need to be hooked up and if it does , does anyone know where I could solder it too?( it does look like the trace runs to a resistor right beside it)

Thanks and great looking site here

edit: I have solder direct to the resistor and replaced chip after reading password from dump, r500 now booting up again. Very Happy
Back to top
View user's profile Send private message
victor
S.F. Boss


Joined: 07 Mar 2004
Posts: 2546
Location: Staff
PostPosted: Thu Jun 14, 2012 8:44 pm    Post subject: Reply with quote
Good to know that Smile
_________________
Victor Voinea
ALLservice HQ, Romania.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Service Forum Forum Index -> Hardware, BIOS repairs All times are GMT + 2 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Powered by phpBB © 2001, 2005 phpBB Group