Service Forum

Fabio · Nou Venit Joined: 27 Jun 2008 Posts: 2

Hi there.

I was given a locked TP R50e and now wanna make it work. Unfortunately this isn't as easy as the old ones where just unpluging the CMOS battery did the trick.

I've used your R24RF08 software to dump and it worked fine.

My only problem right now is that the password shown at lines 0x330 and 0x340 seems to be encrypted. In this case the password shown is Fýgæ“[x .

Should I use W24RF08 in order to rewrite the eeprom or is there any other software that is able to decode this?

Please let me know whether I should buy just W24RF08 licence or something else.

Cheers.

bob · Posted: Sat Jun 28, 2008 2:30 am Post subject:

If the SVP is passphrased you'll need the TCPA reset service and of course, W24RF08.

Could you please email the eeprom dump to take a look? support (at) allservice (dot) ro

Fabio · Nou Venit Joined: 27 Jun 2008 Posts: 2

I've just sent you by e-mail.

Thanks!

William · Nou Venit Joined: 16 Nov 2008 Posts: 2

Hi, all:

I also have a locked TP R50e
Just act as the description in the instruction, I failed to dump the EEPROM content. So could you please give me a introduction what did you do?

Thanks:)