 |
Service Forum
support board, PC repair, unlocking solutions
|
| View previous topic :: View next topic |
| Author |
Message |
sionnet
Nou Venit
Joined: 06 Oct 2009
Posts: 2
|
 Posted: Tue Oct 06, 2009 4:12 pm Post subject: IBM/Lenovo t60 supervisor password |
 |
|
Welcome!
I would like to ask whether by RPC8394 1.0 TPM reader unlock my IBM t60? Do you receive after you purchase the programming schedule that I could build it yourself? |
|
| Back to top |
|
 |
victor
S.F. Boss
Joined: 07 Mar 2004
Posts: 2581
Location: Staff
|
| Posted: Tue Oct 06, 2009 5:21 pm Post subject: |
|
|
Hello,
RPC8394 is enough when T60 is not TCPA locked and passphrase is disabled.
Yes, the software kit contains the interface's blueprints, altough we recommend our ready made kit, you may build it yourself - if that is what you're asking about.
_________________
Victor Voinea
ALLservice HQ, Romania. |
|
| Back to top |
|
|
skygear
Nou Venit
Joined: 05 May 2009
Posts: 8
|
| Posted: Wed Oct 07, 2009 8:38 am Post subject: Re: IBM/Lenovo t60 supervisor password |
|
|
| sionnet wrote: | Welcome!
I would like to ask whether by RPC8394 1.0 TPM reader unlock my IBM t60? Do you receive after you purchase the programming schedule that I could build it yourself? |
buy the interface, saves so much time and headaches |
|
| Back to top |
|
|
sionnet
Nou Venit
Joined: 06 Oct 2009
Posts: 2
|
| Posted: Wed Oct 07, 2009 7:10 pm Post subject: |
|
|
I just sent money to RPC8394 1.0 TPM reader, depends on my time so the programmer to build itself  |
|
| Back to top |
|
|
skygear
Nou Venit
Joined: 05 May 2009
Posts: 8
|
| Posted: Thu Oct 15, 2009 8:19 am Post subject: |
|
|
| sionnet wrote: | | I just sent money to RPC8394 1.0 TPM reader, depends on my time so the programmer to build itself |
understood... but when i sourced all the components and then built the first interface... i wanted it smaller... so i sourced newer and smaller components... had to update my soldering station by then... the soldering station i updated to was defective upon arrival so i decided to just buy the interface instead of waiting for another replacement iron
just perfection |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
