Service Forum

jukuri · Nou Venit Joined: 23 May 2006 Posts: 3

First of all, thanks for Victor, your simple SI-prog works just fine with T-series and 600X.

Unfortunately it does not work with 600E, so I have made Driven-I2C version of it (actually, several versions) with no luck and finally today R.Kawakamis version.
All the circuits, I have made, works just the same way:
Victors tester works fine, but command line ( r24rf08 xxx.bin /x/d/i ) gives me " EEPROM not found "

Yet , I am able to read that same (T20) eeprom with that same Driven-I2C circuit in Ponyprog, save the file as "bin" and translate it successfully with IBMPASS.

Any ideas? Something wrong with command line?

Regards Juha

bob · Posted: Wed Sep 27, 2006 9:31 pm Post subject:

600e has nothing special. I noticed that you typed wrong.
The command is:
r24rf08 xxx.bin /x /d /i - put spaces between params

Pony reads haoticaly, especially on last blocks. The results are enough to see the password sometimes, but the resulting dumps are corrupted.

jukuri · Nou Venit Joined: 23 May 2006 Posts: 3

You are so rigt.
It was the command line, it would be nice to learn to read.
Thank You so much.

Simple-I2C programmer did not work with 600E.

As Victor recently wrote:

" BT has 14pins and you're right, is used in T600e. Anyway BT or CT doesn't matter the eeprom is the same.
But T600e has a lower impedance on SMbus, it is better to use the driven-i2cprog. "

Regards Juha