Service Forum

mtr · Nou Venit Joined: 01 Jul 2008 Posts: 2

Hi

I have read the dump few times with driven-i2cprog interface, from T21, its 1024 bites, but all lines of data shows all zero's

What I am doing wrong?

ie line

0x330 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 . . . . . . . . . . . . . . . .

any help please

thanks

mtr

victor · S.F. Boss Joined: 07 Mar 2004 Posts: 2581 Location: Staff

We got an email where you say is a Toshiba Rolling Eyes

, so I guess is mistake and is a Thinkpad.

If the circuit and/or serial port and/or eeprom connection are ok, you should get a valid dump. Watch out for the "/x /d /i" parameters, if you got the driven one over there.
_________________
Victor Voinea
ALLservice HQ, Romania.

mtr · Nou Venit Joined: 01 Jul 2008 Posts: 2

Yes , sory my mistake, it is IBM Thinkpad T21.

Thanks for your reply. I will check my interface agian and try.

thanks
br
mtr

laptopheaven · Nou Venit Joined: 27 May 2008 Posts: 7 Location: Hamburg

Moin Moin (as we say in Hamburg Smile

I also got this behaviour, when I hooked up the the driven programmer, but the serial port was switched off and no driver was loaded!

The program was reading 1k data just fine, but all the data were zero.

So my advice: Check, if your serial port is really up and running in the device
manager and the driver is available...

greetz
laptopheaven