Service Forum

[shibu]

i got the dump but not able to decode it with ibm pass . 0*336 is blank please help me with it ibmt42

[victor]

If the area is blank, the SVP is not set. Reset the POP (3V cell out) or replace the drive if locked, or else..
_________________
Victor Voinea
ALLservice HQ, Romania.

[shibu]

not able to understand please tell me to me in normal . are you telling me to remove the 3v battery and reset and try

[victor]

I said that when the SVP are is blank, the SVP is not set and is only POP that can be deleted doing a CMOS reset.

I have another idea, email the dump to support_at_allservice.ro, I want to see if there's real blanks or may be the passphrase is set.

Cheers
_________________
Victor Voinea
ALLservice HQ, Romania.

[shibu]

it was pop thank you very much

[chiefmack]

Victor
I have a couple of t42s.
hardware set was pretty easy to make and instructions for downloading software was fine.
followed all direction, however cannot create a dump file.
after hitting F1 it goes to the prompt for master psswrd w/ lock. I run the program on the host PC and I always get a error unable to create file.
file will show up on host PC but it is zero bytes.
I a using mini test probes vice solder.
Mack
_________________
chiefmack

[victor]

R24RF08 gives that message when the disk is read-only, it can't write the dump, not enough space or privileges.

I hope you use the program from within an admin account.
_________________
Victor Voinea
ALLservice HQ, Romania.

[chiefmack]

Hard drive is slicked
should I remove it and then run?
_________________
chiefmack

[victor]

I talked about the techinican PC, where you execute the program.
_________________
Victor Voinea
ALLservice HQ, Romania.