 |
Service Forum
support board, PC repair, unlocking solutions
|
| View previous topic :: View next topic |
| Author |
Message |
serg
Nou Venit
Joined: 29 May 2006
Posts: 3
Location: Russia
|
 Posted: Mon May 29, 2006 11:15 am Post subject: ThinkPad 365 eeprom ndump |
 |
|
Maybe someboby have 93c46 dump for thinkpad
365. I have a big trouble with this machine. during startup it display
error 185 (corrupted boot sequence) then it goes to boot devices select menu i try to reset sequence, use many variants, remove cmos battary,
but have no positive result. I thing that is a bug of a BIOS and now i
need a "cleen" dump for TP 365x. |
|
| Back to top |
|
 |
bob
S.F. Moderator
Joined: 07 Mar 2004
Posts: 802
Location: Staff
|
| Posted: Mon May 29, 2006 12:10 pm Post subject: |
|
|
There's not a bug, just the selected media is not bootable. You have to enter BIOS and Load Setup Defaults that's all.
Tp 365x? I've never seen one |
|
| Back to top |
|
|
serg
Nou Venit
Joined: 29 May 2006
Posts: 3
Location: Russia
|
| Posted: Mon May 29, 2006 12:31 pm Post subject: |
|
|
It's a funny but i can't enter bios cause this error goes me to boot devices
select menu, and not allow to enter EasySetup |
|
| Back to top |
|
|
serg
Nou Venit
Joined: 29 May 2006
Posts: 3
Location: Russia
|
| Posted: Mon May 29, 2006 12:34 pm Post subject: |
|
|
ThinkPad 365X IBM (C)1996
Pentium 100
8 megs ram
1,2Gb HDD
800x600x16M TFT 10'3 |
|
| Back to top |
|
|
victor
S.F. Boss
Joined: 07 Mar 2004
Posts: 2581
Location: Staff
|
| Posted: Tue May 30, 2006 1:05 am Post subject: |
|
|
| Quote: | | Tp 365x? I've never seen one... |
Neither do I.
There is a password to enter EasySetup
I have to dig deep to find your model specs
If is 2625 model try this:
1. Power off the computer.
2. Open the keyboard and lift the right-most section of the insulator sheet.
3. Push out the small door on the right side of the base cover.
4. Apply a short across the Power-On Password Jumper Pads.
5. With the jumper tool in place, power on the computer to clear the password.
6. Remove the jumper and power off the computer.
7. Power on the computer and verify that the password has been cleared.
I hope it worths the effort spent |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
